Once you have decided where you want to position it extended the wiring from its old position to the new.
Installing fluorescent light fixture in garage.
Not only are t8 fluorescent bulbs a great choice for brighter lighting they are also far more economical than other types of lighting.
Flush fluorescent light fixtures come in two basic configurations hard mounting and drop in.
To do this run it through the electrical plastic conduit to protect it.
Many fluorescent lights do not work below 50 degrees.
The hard mounting variety mount between ceiling rafters or other ceiling framing and are secured to.
Photos 2 and 3 show how to remove the old ballast from the fluorescent light fixture.
Remove the bulbs and open up the fixture as shown in photo 1.
The size is easier to work with and is more easily sourced.
The ceiling is unfinished s0 i plan on doing the wiring first.
Installing fluorescent lights and connecting electrical.
Fluorescent lights are the traditional choice for garage spaces.
Look behind the location where the fixtures will be mounted.
Use a stud find if necessary and measure and mark the location on the inside wall where the fixture will be.
However if you live in a cold climate you should choose a fluorescent fixture based on the lowest temperature in your garage.
I want to install t8 fluorescent light fixtures in my garage so i need help with the wiring.
There will be four to eight wires coming out of the ballast.
If there is drywall on the garage walls cut a small access hole at this location.
If you want more light in your garage you can install additional lights on an existing circuit.
Installing a t8 fixture in your garage for fluorescent lighting will give you a much brighter light than incandescent bulbs.
As long as the combined maximum amperage rating of all the fixtures combined doesn t exceed the circuit breaker rating you can install as many fixtures as you want.
Confirm that the new ballast matches the old one photo below and then install it as shown in photo 4.
If the garage is finished with insulation and drywall this can be difficult.
Light fixtures should use 4 foot bulbs.
You need to use the drywall anchor bolts to hold the fluorescent garage lighting in position.