Electronic chlorine generator model ic60 ic40 ic20 and ic15.
Intellichlor ic40 cell light not on.
If this is the case the salt level on the cell will need to be recalibrated.
But i have added salt and used salt testing kit and it shows salt at 3740ppm.
When the intellichlor scg ic15 is installed in europe.
Occasionally the salt indicator on the pentair intellichlor will not match the actual salt level of the pool.
The salt level indicator lights both the red and the green do not seem to be operating.
All other lights are green.
Some of the most experienced problems with pentair ic40 include.
Caution the intellichlor ic15 power supplymust be interconnected with pool pump motor power source.
If i power the system down and then back up the red read more.
The cell light is off and will not come on even with the output at 100.
It is connected to a timer for 7 hours 10am to 5pm.
Intellichlor salt light shows red low salt and cell light is off.
Also i checked the usage by pressing the more button for 3 seconds and it tells you how many hours have been used.
Same sanitation performance as manual chlorine addition without the drawbacks.
I have a pentair intellichlor ic40 installed may 14 2010.
It read 60 which means 6000 hours and the chlorinator only has a life of 10 000.
The intellichlor ic15 power supply fuses must only be obtained from the manufacturer.
The salt level is steady red low.
That means that the pentair ic40 life is running out limited life remaining under proper operation the intellichlor should provide at least 10 000 hrs.
Of operation which is 3 5 years of service.
This guide is only intended for versions 1 9 and below.
The following steps will provide a guide on how to recalibrate a pentair intellichlor.
Intellichlor recommends read more.
No need for customers to buy transport and store chlorine compounds.
A few days ago i observed that the lights were not working.
So its not producing chlorine.
Pentair ic40 problems and solutions.
This ensures the intellichlor scg and pool pump will switch on and off together.
I cleaned the cells by disconnected the ic40 unit and using cell cleaning solution purchased from my local pinch a penny and soaking the unit for about 15 minutes.
