Make sure you do not snag any wires that may be in the ceiling cavity.
Installing recessed lighting first floor.
Cut a hole into the ceiling with a drywall saw.
Drill through the top plate and the joists to create a route for the cables see figure a.
Place an old work electrical.
How to install recessed lights.
Drill a hole in the top plate.
How to install recessed lighting between floors step 1.
Keep the holes centered on the plate and at least 2 in.
Pull cable from the power source to the first recessed light and leave approximately 18 inches of wire hanging from the ceiling.
Hold the recessed light housing up to the ceiling in the desired installation location.
Open the attached junction box on the light and clamp the wires protruding from the ceiling to the box leaving enough run to easily move them as needed.
If an attic is above the ceiling run the wire from the attic.
Watch the entire process step by step.
They have a lower profile and don t require as much height.
Locate an available branch circuit to use as a power source.
So we did some research and figured out how to diy it ourselves.
Their playroom is on the first floor of our two story house so we had no idea how to install recessed lighting without attic access.
Mark the locations of the recessed lights on the ceiling.
Strip the plastic insulation from the end of the wires and use wire nuts to pair the wires together usually color coded black white and a bare ground wire.
Repeat this for each light fixture.
Cut the hole with a drill with a hole cutting attachment and mark all light locations.
It is easier to tap into an existing circuit via a.
Turn off the power to the room at the main circuit breaker.
We called in a professional for a quote which was incredibly high around 1 600 00.
Hold a ceiling electrical box against the ceiling where you will install the fixture and trace the outline of the box.
Test to see if the power is off by inserting a circuit tester plug into an.
How to install recessed lighting without access to the attic.
Use chalk lines to ensure that the lights are aligned.
From the top and bottom of the joists.