If your new sink has larger dimensions than the current countertop opening turn the sink upside down where you want it on the countertop.
Installing new kitchen sink cabinet.
In fact in just a few steps this guide will teach you how to install a bathroom vanity whether you re replacing a bathroom vanity or starting from scratch with.
Then tighten the nut with a basket wrench to secure it in place.
While installing and replacing a bathroom vanity may seem overwhelming or time consuming it doesn t have to be.
Kitchen sink installation in 8 steps step 1 measure and mark the kitchen sink s layout photo by keller keller.
See below for a shopping list tools and.
Prepare the new sink by installing the faucet according to the manufacturer s directions.
Trace the outline and create a new cutout with a jigsaw.
Set the new sink in the countertop hole to verify that it fits.
Place its back edge 1 inches from and parallel to the counter.
Two common sink installation mistakes are one forgetting to clean the new sink thoroughly before.
From there additional cabinets usually are installed on both sides.
Start by adding plumber s putty to the underside of the basket strainer and fit it into the drain hole at the bottom of the sink.
When making measurements and outlines on the wall keep in mind that the cabinet face frames on the cabinet front are 1 2 inch wider than the back of the cabinet.
Proceed to the.
Mark the counter s back edge to center the sink within its cabinet.
If necessary modify the countertop opening using a jigsaw router or tile cutter.
If your kitchen sink drain is corroded and leaking installing a new basket strainer is an easy way to solve the problem.
Check measurements for dishwasher sink and stove openings and also check that the cabinet doors if pre installed open in the proper direction.
Make sure the new sink will cover the old hole check the cutout size before installing new kitchen sink a sink that s too small for the countertop opening will leave ugly gaps along the sides or even fall right through the hole.
If sink has a template align it with the mark on the counter.