2 39 over open.
Install vinyl soffit over open rafters.
Learn to install soffit with your vinyl siding installation.
Many accessories including trim soffit and fascia are available for a vinyl siding job.
A soffit is the horizontal surface under a roof overhang.
Using a level make pencil marks on the wall parallel with the lower edge of wood fascia board at the end of each wall.
To complete the installation follow installation over open.
Soffit panels are most commonly made of vinyl or metal so they re low maintenance and can be found in almost any color to match your exterior color scheme.
If the existing soffit is rotted or damaged remove it completely before installing vinyl soffit then use the instructions for open eaves.
For open overhangs use f trim which has been nailed to the wall of the house.
If installing over an existing soffit and it doesn t have ventilation openings cut openings in it before installing the vinyl soffit in place.
These are for reference points.
A soffit is a covering applied underneath the eaves of your roof.
To make sure the level cut of the rafter tails didn t interfere with the soffit installation i drew the cut 5 1 4 inches from the short point of the plumb cut to provide plenty of clearance.
It is used to cover and protect the exposed ends of the roof rafters and provide a cleaner look to your home.
If the soffit is to turn a corner cut and install j channel to allow 1 4 6 4mm for expansion at each of the adjoining walls and fascia boards.
Basically installation over an enclosed eave is done much in the same manner.
Determine the preferred method of installing soffit at the fascia board.
If you re installing perforated soffit panels and the existing soffit doesn t have openings for ventilation cut an adequate number of openings.
This video includes information on preparation installation over open eaves enclosed eaves and.
Then use the instructions for open eaves.
Its top edge is tucked up under the shingles and its outside face is where the gutter is mounted.
Enclosed eave nailing strip fascia cap or coil stock j channel soffit fig 1 enclosed eave j channel soffit fig.
Installation over enclosed eaves if the existing soffit is rotted or damaged it s best to remove it completely before installing vinyl soffit.
When installing vented soffit panels if the existing soffit doesn t have openings for ventilation cut an adequate number of openings.
The advent of vinyl siding has allowed homeowners with average do it yourself skills to change the look of the exterior of their home more easily than other siding methods such as wood brick or stone.
Fascia and soffits finish the edges of roofs by covering the ends of the roof rafters or roof trusses where they overhang the sides of the house the fascia is the wide board that s installed on edge and runs horizontally along the edge of the roof.