Please follow my page for more tips and check.
Install new ceiling light fixture box.
Determine a location for the light switch.
Step 1 check building codes.
Lower the fixture base and remove the electrical tape or wire nuts from the black hot wire white neutral wire and if present green ground wire.
Move the tip of a.
Strip insulation and make wire splices black to black white to white and ground to ground.
Having confirmed that your existing junction box is securely fastened to the ceiling joist make sure it will be sturdy enough to handle the weight of your replacement fixture.
Run cable into the box and clamp it.
Make sure the power is off.
Attach the wires from the new fixture with wire nuts to the corresponding wires in the electrical box.
Turn off the power to the light fixture at the main circuit panel.
How to install a junction box for a light fixture is fairly easy and should always be done with the power off.
Cut out the traced hole with an oscillating saw.
Remove the nut or screws securing.
Installing a ceiling electrical box lets you add a light fixture to a room.
As an amazon affiliate i get commissions from purchases made from links in the description of my videos.
If the new fixture.
Please help support my channel by using my link to.
The procedure for installing a remodel junction box calls for a pencil drywall saw and screwdriver.
If you want to install a ceiling fan then you will need to get a box rated to hold the weight of a ceiling fan or you will want to add some additional bracing to hold the ceiling fan.
How to hang a ceiling light fixture remove the old fixture and inspect the wiring.
To complete your new light fixture installation slide the canopy up against the ceiling and screw it into place with.
Open the light s junction box.
Installing the box is easily done but you must be careful anytime you are working with electrical wiring.
Trace the outline of the back of the box on the drywall using a pencil.
It should be 48 from the floor.
Fold the wires into the box and replace the cover.
Cut along the trace line with a drywall saw and remove the cutout.
Unscrew the screws or nuts holding the fixture base to the ceiling box.
Place the back of the box on the wall or ceiling and adjust it straight and level.